Using the CLIÉ handheld as a remote control

You can operate a remote-controlled device on the device’s control screen. For those operations you have assigned to the Jog Dial navigator or to the application buttons.

Notes

•	Be sure to point the infrared communications port of your CLIÉ handheld toward the device that you wish to remote-control.
•	The reach of the remote-control signal is approximately 5 meters, but it may vary depending on the receiving device or on the environment.
•	Some buttons on the CLIE Remote Commander application’s control screen would not work if the remote-controlled device is not equipped with that function. Note also that some functions may not work depending on its model.

Remote-controlling a device

Operating a device from the control screen

On the CLIE Launcher screen, rotate the Jog Dial navigator to select CLIE RMC and press the Jog Dial navigator.

Or, tap the CLIE RMC icon on the CLIE Launcher screen.
The CLIE Remote Commander application starts and control screen for the last used device appears.

Note

If the setting for the last used device has been deleted, the Select Control screen appears.

Perform either of the following to switch to the control screen of the device you are about to remote-control.

•	For devices assigned to a quick-start button: Tap the quick-start button to which it is assigned.
•	For devices unassigned to a quick-start button: Tap Select, then tap to select the name of the remote control setting from the list.

The control screen for the selected device appears.

Tap the on-screen buttons to remote-control the device.

Operating devices directly with the Jog Dial navigator or the application button

Follow the steps below to perform the assigned operation from the Jog Dial navigator or the application buttons.

1	Start CLIE Remote Commander.
2	Use the Jog Dial navigator or the application buttons to remote-control the device.

Note

If you hear a long beep sound when you tap on a button, you are not able to perform that operation with the CLIE Remote Commander application. When you are able to perform an operation, you will hear a short beep sound.

Viewing the device name assigned to each quick-start button

Tap a quick-start button and hold for over two seconds. The name of the device assigned to each quick-start button is displayed.