Sending files

Beaming the files

You can beam files to another CLIÉ™ handheld via the infrared communications port.

1	Prepare the receiving and sending CLIÉ™ handhelds for beaming. Make sure that the Beam Receive is set to on in the Preference menu. See Handbook supplied to your CLIÉ™ handheld for details.
2	Point the infrared communications port of the CLIÉ™ handhelds toward each other. For best results, the sending and receiving CLIÉ™ handhelds should be 4 to 8 inches (approximately 10 to 20 centimeters) apart.
3	Tap Menu , Data, then Beam. The list of files appears.
4	Rotate the Jog Dial™ navigator to select the file that you want to send. Then, press the Jog Dial™ navigator . Do not move the CLIÉ™ handhelds until the beaming is complete. When the beaming is complete, the file appears on the receiving CLIÉ™ handheld.

Note

You can only send one file at a time.

To cancel the operation

Tap Cancel in step 3 or 4 above.

Sending files using Bluetooth^®

You can send files to another CLIÉ™ handheld using Bluetooth^® .

1	Prepare the receiving and sending CLIÉ™ handhelds for Bluetooth^® communication. Make sure that the Bluetooth^®is enabled in the Bluetooth screen of the Preferences menu. To use the Bluetooth^® function on your CLIÉ™ handheld, refer to the Handbook supplied with your CLIÉ™ handheld.
2	Tap Menu , Data, then Send. The list of files appears.
3	Tap and select a file that you want to send. The Send With dialog box appears.
4	Tap Bluetooth , then tap OK. Your CLIÉ™ handheld starts searching for a Bluetooth^® devices when connected devices are found. The Discovery Results screen appears.
5	Tap the check box and select a device to connect to, then tap OK. The selected movie file is sent to the connected Bluetooth^® device. When you send still images The Send With dialog box appears. Tap Bluetooth or Bluetooth (BIP), then tap OK. For details, see “Transferring still images to or from a BIP compatible device”.

Note

You can only send one data file at a time.

To cancel the operation

Tap Cancel in step 3, 4, or 5 above.

Attaching the files to e-mails

You can attach the files managed in the CLIE Viewer application to e-mail messages using the CLIE Mail application.

1	Tap . The screen for selecting image files appears.
2	Rotate the Jog Dial™ navigator to select a file that you want to attach and then press the Jog Dial™ navigator, or tap to select the desired file. The CLIE Mail application starts and the Send with CLIE Mail screen appears on the screen.
3	Follow steps 4 to 6 of Writing and sending e-mails.

Note

If you select Send Now, the screen jumps to the Outbox list screen of the CLIE Mail application. If you select Send Later, the screen returns to CLIE Viewer.